Owners Manual

Steps

1. Align the notch on the memory module with the tab on the memory-module slot.

2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.

NOTE: If you do not hear the click, remove the memory module and reinstall it.

NOTE: Repeat step 1 and 2 if there are two memory modules.

3. Align the tabs on the DIMM door with the slots on the system-board shield and snap into place.

Next steps

1. Install the back cover.

2. Install the cable cover (optional).

3. Install the stand.

4. Follow the procedure in After working inside your computer.

System-board shield

Removing the system-board shield

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the stand.

3. Remove the cable cover (optional).

4. Remove the back cover.

About this task

The following image indicates the location of the system-board shield and provides a visual representation of the removal

procedure.

Removing and installing components