Owners Manual

Steps

1. Remove the four screws (M3x5) that secure the bottom cover to the display-assembly base.

2. Lift the bottom cover off the display-assembly base.

Installing the bottom cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the bottom cover and provides a visual representation of the installation

procedure.

Steps

1. Align the screw holes on the bottom cover with the screw holes on the display-assembly base.

2. Replace the four screws (M3x5) to secure the bottom cover to the display-assembly base.

Next steps

1. Install the system-board shield.

2. Install the back cover.

3. Install the cable cover (optional).

4. Install the stand.

5. Follow the procedure in After working inside your computer.

Removing and installing components