Owners Manual

Steps

1. Disconnect the audio-board cable from the connector on the system board.

2. Remove the screw (M3x5) that secure the audio board to the display-assembly base.

3. Lift and remove the audio board with the cable off the display-assembly base.

Installing the audio board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the audio board and provides a visual representation of the removal procedure.

Steps

1. Align the screw hole on the audio board with the screw hole on the display-assembly base.

2. Replace the screw (M3x5) to secure the audio board to the display-assembly base.

3. Connect the audio-board cable to the system board.

Next steps

1. Install the side-I/O board.

2. Install the speakers.

3. Install the rear-I/O bracket.

4. Install the bottom cover.

5. Install the wireless card.

6. Install the system-board shield.

7. Install the back cover.

8. Install the cable cover (optional).

9. Install the stand.

10. Follow the procedure in After working inside your computer.

Removing and installing components