Owners Manual

3. Install the following components:

a) System board shield

b) Back cover

c) Stand

4. Follow the procedure in After working inside your computer.

Pop-Up Camera

Removing the pop-up camera

1. Follow the procedure in Before working inside your computer.

2. Remove the following components:

a) Stand

b) Back cover

c) System board shield

3. To remove the camera assembly:

a) Remove the two screws (M3x5) that secure the camera assembly cover to the middle frame [1].

b) Lift the camera assembly cover away from the middle frame [2].

c) Disconnect the camera cable from the system board and unroute the camera cable from the routing channel [3].

d) Remove the two screws (M3x5) that secure the pop-up camera assembly to the middle frame [4].

e) Slide and lift the pop-up camera assembly off the middle frame [5].

4. To remove the camera bezel:

a) Press the top of the pop-up camera assembly to extend the pop-up camera [1].

b) Remove the three screws (M3x5) that secure the bezel to the pop-up camera assembly [2].

Removing and Installing components