Owner`s manual

Message Description

• If the hard drive is your boot device, ensure that the cables are connected and that the

drive is installed properly and partitioned as a boot device.

• Enter system setup and ensure that the boot sequence information is correct.

No timer tick interrupt A chip on the system board might be malfunctioning.

USB over current

error

Disconnect the USB device. The USB device needs more power for it to function properly. Use

an external power source to connect the USB device, or if the device has two USB cables,

connect both of them.

CAUTION - Hard

Drive SELF

MONITORING

SYSTEM has reported

that a parameter has

exceeded its normal

operating range. Dell

recommends that you

back up your data

regularly. A

parameter out of

range may or may not

indicate a potential

hard drive problem

S.M.A.R.T error or possible hard disk drive failure. Contact Dell and report the issue to a

support technician.