Owner's Manual
Table Of Contents
- Dell OptiPlex 9020 AIO Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- System Overview
- Removing the VESA Stand
- Installing the VESA Stand
- Removing the Back Cover
- Installing the Back Cover
- Removing the Memory
- Installing the Memory
- Removing the VESA Mount Bracket
- Installing the VESA Mount Bracket
- Removing the Power and On-Screen Display (OSD) Buttons Board
- Installing the Power and OSD Buttons Board
- Removing the System-Board Shield
- Installing the System-Board Shield
- Removing the Converter Board
- Installing the Converter Board
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Heat-Sink Assembly
- Installing the Heat-Sink Assembly
- Removing the Processor Fan
- Installing the Processor Fan
- Removing the Power-Supply Fan
- Installing the Power-Supply Fan
- Removing the I/O Board Shield
- Installing the I/O Board Shield
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit
- Removing the Processor
- Installing the Processor
- Removing the Speakers
- Installing the Speakers
- Removing the System Board
- System Board Layout
- Installing the System Board
- Removing the Heat Sink (Graphics Card)
- Installing the Heat Sink (Graphics Card)
- Removing the Antenna Module
- Installing the Antenna Module
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- System Setup
- Technical Specifications
- Contacting Dell
3. Lift the memory shield outwards.
4. Pry the retention clips away from the memory module until it pops-up. Lift and remove the memory module from its
connector.
Installing the Memory
1. Align the notch on the memory-card with the tab in the system-board connector.
2. Press down on the memory module until the release tabs spring back to secure them in place.
3. Place the memory shield back into its place.
4. Install the:
a) back cover
b) VESA stand
5. Follow the procedures in
After Working Inside Your Computer
.
Removing the VESA Mount Bracket
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
a) VESA stand
b) back cover
3. Remove the screws that secure the VESA mount bracket to the computer. Lift the bracket away from the computer.
13