Owner's Manual

25
Installing 11.1.0.7 Patch Set for Oracle Clusterware
NOTE: You must install the patch set software from the node where the RAC 11g
R1 software was installed.
1 Start the Oracle Universal Installer by entering the following in the terminal
window and press
<Enter> :
cd /opt/oracle/patches/Disk1/
./runInstaller
2
The Welcome screen appears. Click Next .
3 In the Specify Home Details screen, click Next .
4 In the Specify Hardware Cluster Installation Mode screen, click Next .
5 In the Summary screen, click Install .
The Oracle Universal Installer scans your system, displays all the patches that
are required to be installed, and installs them on your system. When the
installation completes, the
End of Installation screen appears.
NOTE: This procedure may take several minutes to complete.
6 Read all the instructions in the message window that is displayed.
NOTE: Do not shut down the Oracle Clusterware daemons, as you already
performed this procedure in step 1 and step 2.
7 Open a terminal window.
8 Log in as root .
9 Type the following and press <Enter> :
$ORA_CRS_HOME/install/root111.sh
10
Repeat step 7 through step 9 on the remaining nodes, one node at a time.
11 On the first node, return to the End of Installation screen.
12 Click Exit .
13 Click Yes to exit the Oracle Universal Installer.