Administrator Guide

Example of the find Keyword
DellEMC#show system brief | find Management
1 Management online S6100-ON S6100-ON 9.10(0.0) 130
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
---------------------------------------------------------------------------
1 1 up AC up 9168
The display command displays additional configuration information.
The no-more command displays the output all at once rather than one screen at a time. This is similar to the terminal
length command except that the no-more option affects the output of the specified command only.
The save command copies the output to a file for future reference.
NOTE: You can filter a single command output multiple times. The save option must be the last option entered. For
example: DellEMC# command | grep regular-expression | except regular-expression | grep
other-regular-expression | find regular-expression | save.
Multiple Users in Configuration Mode
Dell EMC Networking OS notifies all users when there are multiple users logged in to CONFIGURATION mode.
A warning message indicates the username, type of connection (console or VTY), and in the case of a VTY connection, the IP
address of the terminal on which the connection was established. For example:
● On the system that telnets into the switch, this message appears:
% Warning: The following users are currently configuring the system:
User "<username>" on line console0
● On the system that is connected over the console, this message appears:
% Warning: User "<username>" on line vty0 "10.11.130.2" is in configuration mode
If either of these messages appears, Dell EMC Networking recommends coordinating with the users listed in the message so
that you do not unintentionally overwrite each other’s configuration changes.
Configuring alias command
You can configure shorter alias names for single–line command input using the alias command.
To configure the alias name, perform the following steps:
1. Configure the terminal to enter the Global Configuration mode.
EXEC Privilege mode
DellEMC#configure terminal
2. Configure the system to enter the alias-definition mode.
CONFIGURATION mode
DellEMC(conf)#alias-definition
3. Create the alias name followed by the single–line CLI.
ALIAS DEFINITION CONFIGURATION mode
DellEMC(conf-alias-definition)#alias sr show running-config
4. Display the aliases and its definition.
EXEC Privilege mode
show alias
Configuration Fundamentals
41