CLI Guide

Version Description
pre-6.2.1.0 Introduced on the E-Series.
port
Configures NAS port number to accept CoA or DM requests.
Syntax
port port-number
To remove the NAS port configuration, enter the no port command.
Defaults 3799
Parameters
port-number Enter the NAS port number to accept CoA and DM requests. The range is from 1 to
65535.
Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Optionally specify dynamic authorization port number. Default port is 3799.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
radius dynamic-auth
Enters a new sub-mode, RADIUS-DYNAMIC-AUTH, which enables you to modify dynamic authorization settings.
Syntax
radius dynamic-auth
To remove the dynamic authorization method for RADIUS users, enter the no radius dynamic-auth
command.
Defaults Disabled.
Command Modes
● CONFIGURATION
Usage
Information
● All dynamic authorization commands are configured by entering this mode.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
Security 1367