CLI Guide

NOTE: Use this attribute to specify the VRF that is used by the SNMP engine
to reach the device. If no VRF is specified, then the default VRF is used.
udp-port port-
number engineID
Enter the keywords udp-port followed by the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
Defaults As above.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Changing the value of the SNMP Engine ID has important side effects. A user’s password (entered on
the command line) is converted to a message digest algorithm (MD5) or secure hash algorithm (SHA)
security digest. This digest is based on both the password and the local Engine ID. The command line
password is then destroyed, as required by RFC 2274. Because of this deletion, if the local value of
the Engine ID changes, the security digests of SNMPv3 users is invalid and the users will have to be
reconfigured.
For the remote Engine ID, the host IP and UDP port are the indexes to the command that are matched to
either overwrite or remove the configuration.
Related
Commands
● show snmp engineID — displays the SNMP engine and all the remote engines that are configured on
the router.
● show running-config snmp — displays the SNMP running configuration.
1466 Simple Network Management Protocol (SNMP) and Syslog