CLI Guide

show config
Display the current ACL configuration.
Syntax
show config
Command Modes
● CONFIGURATION-STANDARD-ACCESS-LIST
● CONFIGURATION-EXTENDED-ACCESS-LIST
● CONFIGURATION-MAC ACCESS LIST-STANDARD
● CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
DellEMC(config-std-nacl)# show conf
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24 count
remark 10 Deny traffic from ABC
seq 10 deny 2.1.1.0/24 count
DellEMC(config-std-nacl)#
Common IP ACL Commands
The following commands are available within both Ingress and Egress IP ACL modes (Standard and Extended) and do not have
mode-specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an
implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
Access Control Lists (ACL) 183