CLI Guide

Parameters
access-list-name Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any,” that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
Dell EMC Networking OS supports one ingress and one egress IP ACL per interface.
Prior to Dell EMC Networking OS version 7.8.1.0, names are up to 16 characters long.
The number of entries allowed per ACL is hardware-dependent. For detailed specifications on entries
allowed per ACL, refer to your line card documentation.
Example
DellEMC(conf)# ip access-list standard TestList
DellEMC(config-std-nacl)#
Related
Commands
● ip access-list extended — create an extended access list.
● show config — display the current configuration.
permit
To permit packets from a specific source IP address to leave the switch, configure a filter.
Syntax
permit {source [mask]| any | host ip-address} [count [bytes] | log] [dscp
value] [ecn value] [fragments] [monitor ] [no-drop] [order]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
192 Access Control Lists (ACL)