CLI Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

381

382

383

384

385

386

387

388

389

390

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage

Information

To prevent loops, the neighbor ebgp-multihop command does not install the default routes of the

multihop peer. Networks not directly connected are not considered valid for best-path selection.

neighbor fall-over

Enable or disable fast fall-over for BGP neighbors.

Syntax

neighbor {ipv4-address | peer-group-name} fall-over

To disable, use the no neighbor {ipv4-address | peer-group-name} fall-over command.

Parameters

ipv4-address

Enter the IP address of the neighbor in dotted decimal format.

peer-group-name

Enter the name of the peer group.

Defaults Disabled.

Command Modes ROUTER BGP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.