Glossary

2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1 and RIPv2
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
If you want the interface to receive both versions of RIP, use the ip rip receive version 1 2
command.
Related
Commands
● ip rip send version — sets the RIP version for sending RIP traffic on an interface.
● version — sets the RIP version the switch software uses.
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in
ROUTER RIP mode.
S4048–ON
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1 (OPTIONAL) Enter the number 1 for RIP version 1. The default is RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1
Command Modes INTERFACE
Routing Information Protocol (RIP) 1319