Glossary

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S–Series.
Usage
Information
Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route forwarding table if it was
deleted using the no ip unknown-unicast command previously. This will be the default configuration
after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
All the default catch-all entries in the longest prefix match (LPM) table collect and transmit all unresolved
IPv6 packets to the CPU, even if they are destined for unknown destinations.
show cpu-queue rate cp
Display the rates for each CPU queue.
Syntax
show cpu-queue rate cp
Defaults Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
482 Control Plane Policing (CoPP)