Glossary

ManualsBrandsDell ManualsAccess PlatformsOS9

671

672

673

674

675

676

677

678

679

680

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

Usage

Information

To enable IGMP snooping, enter this command. When you enable this command from CONFIGURATION

mode, IGMP snooping enables on all VLAN interfaces (except the default VLAN).

NOTE: Execute the no shutdown command on the VLAN interface for IGMP Snooping to function.

ip igmp snooping fast-leave

Enable IGMP snooping fast-leave for this VLAN.

Syntax

ip igmp snooping fast-leave

To disable IGMP snooping fast leave, use the no igmp snooping fast-leave command.

Defaults Not configured.

Command Modes INTERFACE VLAN — (conf-if-vl-n)

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.