Install Guide

Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Added support for the access parameter.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The following example specifies the group named harig as a version 3 user requiring both authentication
and encryption and read access limited to the read named rview.
NOTE: The number of configurable groups is limited to 16 groups.
Example
DellEMC# conf
DellEMC(conf)# snmp-server group harig 3 priv read rview
DellEMC#
Related
Commands
● show snmp group — displays the group name, security model, view status, and storage type of each
group.
● show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps | informs
[version 1 | 2c | 3] [auth | no auth | priv] [community-string] [udp-port
port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [vrf vrf-name]
traps | informs [version 1 | 2c | 3] [auth | noauth | priv] [community-
string] [udp-port number] [notification-type] command.
Parameters
ip-address Enter the keyword host then the IP address of the host (configurable hosts is
limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
vrf vrf-name Enter the keyword vrf and then the name of the VRF that the SNMP server uses
to connect to the host.
1476 Simple Network Management Protocol (SNMP) and Syslog