Install Guide

Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If all
interfaces are configured under VRF, at least one interface should be in the default VRF for the router
bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
DellEMC(conf)# router bgp 3
DellEMC(conf-router_bgp)#
shutdown all
Disables all the BGP neighbors.
Syntax
shutdown all
Use the no shutdown all command to enable all the configured BGP neighbors.
Command Modes ROUTER BGP
Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage
Information
You can use this command to disable all the configured BGP neighbors.
This command is global for all VRFs.
406 Border Gateway Protocol