Setup Guide

Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced MAC address notification traps on all the Dell EMC Networking OS
platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148 and S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for config and ecmp traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP notification types. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To configure the router to send SNMP notifications, enter at least one snmp-server host command.
If you enter the command with no keywords, all trap types are enabled for the host. If you do not enter an
snmp-server host command, no notifications are sent.
In order to enable multiple hosts, issue a separate snmp-server host command for each host. You can
specify multiple notification types in the command for each host.
When multiple snmp-server host commands are given for the same host and type of notification
(trap or inform), each succeeding command overwrites the previous command. Only the last snmp-
server host command will be in effect. For example, if you enter an snmp-server host inform
command for a host and then enter another snmp-server host inform command for the same host,
the second command replaces the first command.
The snmp-server host command is used with the snmp-server enable command. Use the
snmp-server enable command to specify which SNMP notifications are sent globally. For a host
to receive most notifications, at least one snmp-server enable command and the snmp-server
host command for that host must be enabled.
NOTE: For v1 / v2c trap configuration, if the community-string is not defined using the snmp-
server community command prior to using this command, the default form of the snmp-server
community command automatically is configured with the community-name the same as specified in
the snmp-server host command.
Configuring Informs
To send an inform, use the following steps:
1456
Simple Network Management Protocol (SNMP) and Syslog