Setup Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage
Information
Prior to disabling the stackable VLAN feature, remove the members.
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable VLANs
contain members, designated by the M in the Q column of the command output.
If you enabled VRF, you cannot enable the stacked VLAN feature using this command.
If you enabled IGMP snooping, you cannot enable the stacked VLAN feature using this command.
Example
DellEMC# show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Gi 1/13
M Gi 1/1-3
3 Active M Po1(Gi 1/14-15)
M Gi 1/18
M Gi 1/4
4 Active M Po1(Gi 1/14-15)
M Gi 1/18
M Gi 1/5
5 Active M Po1(Gi 1/14-15)
M Gi 1/18
M Gi 1/6
DellEMC#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to an S-Tag dot1p value.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
1600 VLAN Stacking