Users Guide

Table Of Contents
Ring ID: the range is from 1 to 255.
Troubleshooting FRRP
To troubleshoot FRRP, use the following information.
Configuration Checks
Each Control Ring must use a unique VLAN ID.
Only two interfaces on a switch can be Members of the same control VLAN.
There can be only one Master node for any FRRP group.
You can configure FRRP on Layer 2 interfaces only.
Spanning Tree (if you enable it globally) must be disabled on both Primary and Secondary interfaces when you enable FRRP.
When the interface ceases to be a part of any FRRP process, if you enable Spanning Tree globally, also enable it explicitly
for the interface.
The maximum number of rings allowed on a chassis is 255.
Sample Configuration and Topology
The following example shows a basic FRRP topology.
Example of R1 MASTER
interface TenGigabitEthernet 1/24/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/31/1
no ip address
switchport
no shutdown
!
interface Vlan 101
no ip address
tagged TenGigabitEthernet 1/24/1,1/31/1
no shutdown
!
interface Vlan 201
no ip address
tagged TenGigabitEthernet 1/24/1,131/1
no shutdown
!
protocol frrp 101
interface primary TenGigabitEthernet 1/24/1
secondary TenGigabitEthernet 1/31/1 control-vlan 101
member-vlan 201
mode master
no disable
Example of R2 TRANSIT
interface TenGigabitEthernet 1/14/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/11/1
no ip address
switchport
no shutdown
!
Force10 Resilient Ring Protocol (FRRP)
331