White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

1091

Table Of Contents

Version Description

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

9.0.2.0 Introduced on the S6000..

8.3.11.1 Introduced on the Z9000.

8.3.8.0 Introduced on the S4810.

Usage

Information

LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In

throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the

maximum time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval

100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec

is reached.

timers throttle lsa arrival

Configure the LSA acceptance intervals.

Syntax

timers throttle lsa arrival arrival-time

To return to the default, use the no timers throttle lsa command.

Parameters

arrival-time

Set the interval between receiving the same LSA repeatedly, to allow sufficient

time for the system to accept the LSA. The range is from 0 to 600,000

milliseconds.

Defaults 1000 msec

Command Modes ROUTER OSPF

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.