White Papers

speed (Management interface)
Set the speed for the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● management route — configure a static route that points to the Management interface or a
forwarding router.
switchport
Place an interface in Layer 2 mode.
Syntax
switchport [[backup interface {interface | port-channel number}] | mode
private-vlan {host | promisucous | trunk}]
Interfaces 671