White Papers

Version Description
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Introduced for the E-Series.
Usage
Information
This command disables the incrementing of the hops field when boot requests are relayed to a DHCP
server through Dell EMC Networking OS. If the incoming boot request already has a non-zero hops field,
the message is relayed with the same value for hops. However, the message is discarded if the hops field
exceeds 16, to comply with the relay agent behavior specified in RFC 1542.
Related
Commands
● ip helper-address — specify the destination broadcast or host address for DHCP server requests.
● show running-config — display the current configuration and changes from the default values.
ip host
Assign a name and an IP address to the host-to-IP address mapping table.
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
724 IPv4 Routing