Administrator Guide

seq 5 permit host 10.11.0.1
DellEMC(config-std-nacl)#line vty 0
DellEMC(config-line-vty)#show config
line vty 0
access-class myvtyacl
DellEMC(conf-ipv6-acl)#do show run acl
!
ip access-list extended testdeny
seq 10 deny ip 30.1.1.0/24 any
seq 15 permit ip any any
!
ip access-list extended testpermit
seq 15 permit ip any any
!
ipv6 access-list testv6deny
seq 10 deny ipv6 3001::/64 any
seq 15 permit ipv6 any any
!
DellEMC(conf)#
DellEMC(conf)#line vty 0 0
DellEMC(config-line-vty)#access-class testv6deny ipv6
DellEMC(config-line-vty)#access-class testvpermit ipv4
DellEMC(config-line-vty)#show c
line vty 0
exec-timeout 0 0
access-class testpermit ipv4
access-class testv6deny ipv6
!
Configuring Login Authentication for Terminal Lines
You can use any combination of up to six authentication methods to authenticate a user on a terminal line.
A combination of authentication methods is called a method list. If the user fails the first authentication method, Dell EMC
Networking OS prompts the next method until all methods are exhausted, at which point the connection is terminated. The
available authentication methods are:
enable
Prompt for the enable password.
line
Prompt for the password you assigned to the terminal line. Configure a password for the terminal line to
which you assign a method list that contains the line authentication method. Configure a password using
the password command from LINE mode.
local
Prompt for the system username and password.
none
Do not authenticate the user.
radius
Prompt for a username and password and use a RADIUS server to authenticate.
tacacs+
Prompt for a username and password and use a TACACS+ server to authenticate.
1. Configure an authentication method list. You may use a mnemonic name or use the keyword default. The default
authentication method for terminal lines is local and the default method list is empty.
CONFIGURATION mode
aaa authentication login {method-list-name | default} [method-1] [method-2] [method-3]
[method-4] [method-5] [method-6]
2. Apply the method list from Step 1 to a terminal line.
CONFIGURATION mode
login authentication {method-list-name | default}
3. If you used the line authentication method in the method list you applied to the terminal line, configure a password for the
terminal line.
LINE mode
password
74
Management