CLI Guide

Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON,
and Z9100–ON.
Usage
Information
Use the local-vtep-ip IP Address command to set the local IP Address that would be used as
source for VXLAN tunnels.
max_backoff
Configures time to wait between connection attempts with controller.
Syntax
max_backoff time
Parameters
time Enter the time in milliseconds. The range is from 1000-180000. The default value is
30000.
Defaults 30000
Command Modes VXLAN INSTANCE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.10(0.1P10) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S6000.
Usage
Information
The retry interval value caps at the value configured on the max-backoff.
Related
Commands
vxlan-instance — Enable VXLAN Instance configuration on the platform.
peer-ovsdbserver-ip
Specify the IP address of the peer OVSDB server in a VLT setup.
Syntax
peer-ovsdbserver-ip peer-ip-address
To remove the configuration, use the no peer-ovsdbserver-ip
Parameters
peer-ip-address Enter the peer OVSDB server IP address. This is usually the management IP
address of the peer VLT device.
Defaults Not configured
Command Modes VXLAN-INSTANCE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
1668 Virtual Extensible LAN (VXLAN)