CLI Guide

IPv6 VRRP Commands
The following are IPv6 VRRP commands.
● clear counters vrrp ipv6
● debug vrrp ipv6
● show vrrp ipv6
● vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
● advertise-interval
●
description
● disable
● hold-time
● preempt
● priority
● show config
● virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group; range is from 1 to 255.
vrf vrf-name (OPTIONAL) Enter the name of a VRF instance to clear the counters of all IPv6
VRRP groups in the specified VRF. The maximum is 32 characters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.9(0.0) Added support to clear the interface configurations corresponding to a range of
ports.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series, C-Series, and S-Series. Support was added for IPv6 VRRP
groups in nondefault VRF instances.
8.3.2.0 Introduced on the E-Series.
1698 Virtual Router Redundancy Protocol (VRRP)