CLI Guide

Version Description
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
The continue feature allows movement from one route-map entry to a specific route-map entry
(the sequence number). If you do not specify the sequence number, the continue feature simply
moves to the next sequence number (also known as an implied continue). If a match clause exists, the
continue feature executes only after a successful match occurs. If there are no successful matches,
the continue feature is ignored.
Match clause with Continue clause
The continue feature can exist without a match clause. A continue clause without a match clause
executes and jumps to the specified route-map entry.
With a match clause and a continue clause, the match clause executes first and the continue clause next
in a specified route map entry. The continue clause launches only after a successful match. The behavior
is:
● A successful match with a continue clause, the route map executes the set clauses and then goes to
the specified route map entry upon execution of the continue clause.
● If the next route map entry contains a continue clause, the route map executes the continue clause if
a successful match occurs.
● If the next route map entry does not contain a continue clause, the route map evaluates normally.
If a match does not occur, the route map does not continue and falls through to the next sequence
number, if one exists.
Set Clause with Continue Clause
If the route-map entry contains sets with the continue clause, set actions are performed first then the
continue clause jumps to the specified route map entry.
● If a set action occurs in the first route map entry and then the same set action occurs with a different
value in a subsequent route map entry, the last set of actions overrides the previous set of actions
with the same set command.
● If set community additive and set as-path prepend are configure, the communities and
AS numbers are prepended.
Related
Commands
● set community — specify a COMMUNITY attribute.
● set as-path — configure a filter to modify the AS path.
description
Add a description to this route map.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the route map (80 characters maximum).
Defaults None
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
258 Access Control Lists (ACL)