CLI Guide

show hardware pfc-nodrop-priority
View the packets drop count corresponding to the priority.
Syntax
show hardware pfc-nodrop-priority l2-dlf drops stack-unit stack-unit-number
port-set port-pipe
Parameters
stack-unit stack-
unit-number
Enter the keywords stack-unit and the stack unit number.
port-set port-
pipe
Enter the keywords port-set and port-pipe number. The port-pipe number is 0.
Command Modes
EXEC
EXEC Privilege
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the C9010, S6000, S6000–ON, Z9100–ON and S6100–ON.
Example
DellEMC#show hardware pfc-nodrop-priority l2-dlf drops stack-unit 1 port-set 0
---------------------------------------------------
Priority DropCount
---------------------------------------------------
0 0
1 0
2 0
3 0
4 0
5 0
6 0
7 0
Related
Commands
pfc-nodrop-priority l2-dlf drop — configures to drop the unknown unicast packets flooding on lossless
priorities.
show interface pfc
Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
Syntax
show interface port-type slot/port[/subport] pfc {summary | statistics |
detail | buffer-threshold}
Parameters
port-type slot/
port[ /subport ]
pfc
Enter the port-type slot and port PFC information. Enter the subport number if a
port is fanned-out into 10G ports.
{summary |
statistics |
detail | buffer-
threshold}
Enter the keyword summary for a summary list of results or enter the keyword
detail for a full list of results. Enter the keyword statistics to view pfc
statistics. Use the keyword buffer-threshold to display the buffer threshold
details.
NOTE: This command also enables you to view information corresponding to a range of ports.
However, for Open Networking (ON) platforms the notation for specifying port range in the
command is different from how you specify in non-ON platforms.
● For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you
want to display information corresponding to all ports between 1 and 4, specify the port range as
show interfaces interface-type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to display information corresponding to all ports between 1 and
4, specify the port range as show interfaces interface-type 1/1/1 - 1/1/4.
Data Center Bridging (DCB) 479