CLI Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

631

632

633

634

635

636

637

638

639

640

Table Of Contents

Command Modes INTERFACE (conf-if-interface-slot/port)

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the C-Series and S-Series.

7.6.1.0 Introduced on E-Series.

Usage

Information

The access list accepted is an extended ACL. To block IGMP reports from hosts, on a per-interface basis

based on the group address and source address that you specify in the access list, use this feature.

ip igmp immediate-leave

Enable IGMP immediate leave.

Syntax

ip igmp immediate-leave [group-list prefix-list-name]

To disable ip igmp immediate leave, use the no ip igmp immediate-leave command.

Parameters

group-list

prefix-

list-name

Enter the keywords group-list then a string up to 16 characters long of the

prefix-list-name.

Defaults Not configured.

Command Modes INTERFACE