CLI Guide

advertise med softphone-voice
To advertise softphone to enable IP telephony on a computer so that the computer can be used as a phone, configure the
system.
Syntax
advertise med softphone-voice {vlan-id layer2_priority DSCP_value} |
{priority-tagged number}
To return to the default, use the no advertise med softphone-voice {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged, the Layer 2 priority, and then the DSCP
value.
Defaults Unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
● debug lldp interface — debug LLDP.
● show lldp neighbors — display the LLDP neighbors.
Link Layer Discovery Protocol (LLDP) 943