Users Guide

Version Description
9.11(0.0) Introduced on the C9010.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related
Commands
● ipv6 nd ra-guard enable — configure the RA guard related commands.
● ipv6 nd raguard policy policy-name — define the router advertisement (RA) guard policy name and
enter the RA guard policy configuration mode.
match ra
Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address in the inspected
messages. If this command is not configured, the verification process is bypassed.
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-access-list
name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-prefix-list |
mac-access-list}command.
Parameters
ipv6–access-list
name
Enter the keywords ipv6–access-list then the access-list name. The access-
list name allows a maximum of 140 characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list name. The prefix-list
name allows a maximum of 140 characters.
ipv6–mac-
access-list name
Enter the keywords ipv6–mac-access-list then the mac-access-list name.
The mac-access-list name allows a maximum of 140 characters.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11(0.0) Introduced on the C9010.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.9(0.0) Introduced on the Z9500.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
Neighbor Discovery Protocol (NDP) 1031