Users Guide

Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced
Usage
Information
The access name is an extended IP access list that denies PIM register packets to RP at the source DR
based on the multicast and group addresses. Do not enter this command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-address mask}
[override]
To remove an RP address, use the no ip pim [vrf vrf-name] rp-address address
{group-address group-address mask} [override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
address Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords group-address then a group-address mask, in dotted
decimal format (/xx), to assign that group address to the RP.
override Enter the keyword override to override the BSR updates with static RP. The
override takes effect immediately during enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
PIM-Sparse Mode (PIM-SM) 1191