Users Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

201

202

203

204

205

206

207

208

209

210

no-drop Enter the keywords no-drop to match only the forwarded packets.

Defaults Not configured

Command Modes CONFIGURATION-STANDARD-ACCESS-LIST

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.12(1.0) Introduced on the S5048F–ON.

9.12(0.0) Removed the session–ID option from the monitor parameter.

9.11(0.0) Added support for session–ID to the monitor parameter.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.8(0.0) Added the no-drop parameter.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.3.1.0 Add the DSCP value for ACL matching.

8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.

8.1.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 Added support for the non-contiguous mask and added the monitor option.

6.5.10 Expanded to include the optional QoS order priority for the ACL entry.

Usage

Information

The order option is relevant in the context of the Policy QoS feature only. The following applies:

● The seq sequence-number command is applicable only in an ACL group.

● The order option works across ACL groups that are applied on an interface via the QoS policy

framework.

● The order option takes precedence over seq sequence-number.

● If you do not configure sequence-number, the rules with the same order value are ordered

according to their configuration order.

● If you configure sequence-number, the sequence-number is used as a tie breaker for rules with the

same order.

Commands

● deny — configure a filter to drop packets.

● permit — configure a filter to forward packets.

202 Access Control Lists (ACL)