Administrator Guide

group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this LAG fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG number. Enter this
keyword/variable combination twice, identifying the two paired LAGs.
Defaults None
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
● port-channel failover-group — access PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG
failover group.
● show interfaces port-channel — display information on configured Port Channel groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing 16 physical interfaces on the S-Series.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 4096.
Defaults Not configured.
698 Interfaces