CLI Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.9(0.0) Introduced on the Z9500.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, Introduced on the S6000–ON,
and Z9000 switches.
Example
DellEMC# show ipv6 nd ra-guard policy test
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 1
match ra ipv6-access-list access
other-config-flag on
router-preference maximum medium
trusted-port
Interfaces :
Gi 1/1
DellEMC#
Related
Commands
● ipv6 nd ra-guard enable — configure the RA guard related commands.
● ipv6 nd ra-guard policy — define the RA guard policy name and enter the RA guard policy list
configuration mode.
● device-role — specify the role of the device attached to the port.
● hop-limit — enable the verification of the advertised hop count limit.
● mtu — set the maximum transmission unit (MTU) value.
● other-config-flag — enable the verification of the advertised other configuration parameter.
● reachable-time — set the advertised reachability time.
● retrans-timer — set the advertised retransmission time.
● router-preference maximum — enable the verification of the advertised default router preference
(DRP) value.
● trusted-port — apply the policy to trusted ports.
● ipv6 nd raguard attach-policy — apply the IPv6 RA guard to a specific interface.
trusted–port
Allow bypassing the configured RA guard validation and forwards the RA packets received on the interface, which has the
trusted port policy attached.
Syntax
trusted-port
To reset the policy applied to the trusted port, use the no trusted-port command.
Defaults None
Command Modes POLICY LIST CONFIGURATION
1000 Neighbor Discovery Protocol (NDP)