CLI Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Example
DellEMC# debug track all
04:35:04: %RPM0-P:RP2 %OTM-5-STATE: track 6 - Interface GigabitEthernet
1/2
line-protocol DOWN
04:35:04: %RPM0-P:RP2 %OTM-5-NOTIF: VRRP notification: resource ID 6 DOWN
delay
Configure the time delay used before communicating a change in the status of a tracked object to clients.
Syntax
delay {[up seconds] [down seconds]}
To return to the default setting, use the no delay command.
Parameters
seconds Enter the number of seconds the object tracker waits before sending a notification
about the change in the UP and/or DOWN state of a tracked object to clients. The
range is 0 to 180. The default is 0 seconds.
Defaults 0 seconds
Command Modes OBJECT TRACKING (conf_track_object-id)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage
Information
You can configure an UP and/or DOWN timer for each tracked object to set the time delay before a
change in the state of a tracked object is communicated to clients. The configured time delay starts when
the state changes from UP to DOWN or vice-versa.
If the state of an object changes back to its former UP/DOWN state before the timer expires, the timer is
cancelled and the client is not notified. For example, if the DOWN timer is running when an interface goes
down and comes back up, the DOWN timer is cancelled and the client is not notified of the event.
Object Tracking 1003