CLI Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

381

382

383

384

385

386

387

388

389

390

Table Of Contents

Defaults Not configured.

Command Modes ROUTER BGP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.8.0 Introduced the limit keyword on the S4810.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage

Information

After you configure a peer group as passive, assign it a subnet using the neighbor soft-

reconfiguration inbound command.

For passive eBGP limits, the Remote AS must be different from the AS for this neighbor.

Commands

● neighbor soft-reconfiguration inbound — assign a subnet to a dynamically configured BGP neighbor.

● neighbor remote-as — assign an indirectly connected AS to a neighbor or peer group.

neighbor remote-as

Create and specify the remote peer to the BGP neighbor.

Syntax

neighbor {ip-address | peer-group-name} remote-as number

To delete a remote AS entry, use the no neighbor {ip-address | peer-group-name}

remote-as number command.

Parameters

ip-address

Enter the IP address of the neighbor to enter the remote AS in its routing table.

peer-group-name

Enter the name of the peer group to enter the remote AS into routing tables of all

routers within the peer group.

number

Enter a number of the AS. The range is from 0 to 65535 (2 byte) or from 1 to

4294967295 (4 byte).