CLI Guide

Version Description
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors in the cluster do not
need not to be fully meshed. By default, when you use no route reflector, the internal BGP (IBGP)
speakers in the network must be fully meshed.
The first time you enter this command, the router configures as a route reflector and the specified BGP
neighbors configure as clients in the route-reflector cluster.
When you remove all clients of a route reflector using the no neighbor route-reflector-client
command, the router no longer functions as a route reflector.
If the clients of a route reflector are fully meshed, you can configure the route reflector to not reflect
routes to specified clients by using the no bgp client-to-client reflection command.
This command automatically restarts the neighbor session for the configuration to take effect.
Related
Commands
● bgp client-to-client reflection — enable route reflection between the route reflector and the clients.
neighbor sender-side-loopdetect
Enables sender-side loop detection for BGP.
Syntax
neighbor {ip-address | peer-group-name} sender-side-loopdetect
To disable sender-side loop detection, use the no neighbor {ip-address | peer-group-name}
sender-side-loopdetect command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to enable or disable all routers with in the peer
group.
All routers in the peer group receive routes from a route reflector.
Defaults Enabled.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
394 Border Gateway Protocol