CLI Guide

Usage
Information
This command causes the Ring Manager to take ownership of the two ports after IFM validates the
configuration. Ownership is relinquished for a port only when the interface does not play a part in any
control VLAN, that is, the interface does not belong to any ring.
Related
Commands
● show frrp — display the Resilient Ring Protocol configuration information.
member-vlan
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by commas), a range of
VLAN IDs (separated by a hyphen), a single VLAN ID, or a combination. For
example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Combination: 3, 4, 5-10, 8.
Defaults None
Command Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
mode
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
Force10 Resilient Ring Protocol (FRRP) 559