CLI Guide

Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for example, /24).
secondary (OPTIONAL) Enter the keyword secondary to designate the IP address as the
secondary address.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
You must be in INTERFACE mode before you add an IP address to an interface. Assign an IP address to
an interface prior to entering ROUTER OSPF mode.
ip directed-broadcast
Enables the interface to receive directed broadcast packets.
Syntax
ip directed-broadcast
To disable the interface from receiving directed broadcast packets, use the no ip directed-
broadcast command.
Defaults Disabled (that is, the interface does not receive directed broadcast packets)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
IPv4 Routing 717