CLI Guide

cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos]
number ecfmacl number {fcoeacl number} {iscsioptacl {0|2}} {openflow {4|8}}
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L2Acl : 6
● IPV4Acl : 4
● IPV6Acl : 0
● IPV4Qos : 2
● L2Qos : 1
● L2PT : 0
● IpMacAcl : 0
● VmanQos : 0
● VmanDualQos : 0
●
EcfmAcl : 0
● nlbclusteracl: 0
● FcoeAcl : 0
● iscsiOptAcl : 0
● ipv4pbr : 0
● vrfv4Acl :0
● Openflow : 0
● fedgovacl : 0
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be allotted. The
total space allocated must equal to 13. The ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
● 4: Creates 242 entries for use by the OpenFlow controller (256 total entries
minus the 14 entries reserved for internal functionality)
● 8: Creates 498 entries for use by the OpenFlow controller (512 total entries
minus the 14 entries reserved for internal functionality)
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
88 Control and Monitoring