Deployment Guide

Version Description
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
This command is useful in isolating routing problems between the OSPF and the RTM. For example, if a
route is missing from the RTM/FIB but is visible from the display output of this command, the problem is
with downloading the route to the RTM.
This command has the following limitations:
● The display output is sorted by prefixes; intra-area ECMP routes are not displayed together.
● For Type 2 external routes, Type 1 cost is not displayed.
NOTE: Starting with Version 9.4(0.0), the loopback IP address advertised to the neighbor is not
displayed in the output because they are not accounted as inactive OSPF routes, whereas the
loopback IP address is displayed until Dell EMC Networking OS Version 9.3(0.0). Starting with
Version 9.4(0.0), the show ip ospf routes command displays the interface and area ID information of
connected networks in addition to the other settings, whereas these details are not displayed until
Dell EMC Networking OS Version 9.3(0.0). Starting with Version 9.4(0.0), the metric of E2 routes in
the output is displayed as an external metric, whereas until Dell EMC Networking OS Version
9.3(0.0), the number of hops to the ASBR for E2 routes are displayed in the output.
Example
DellEMC# show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Te 1/4/1 1 Intra-Area
13.0.0.0 1 0.0.0.0 Te 1/4/1 0 Intra-Area
150.150.150.0 2 13.0.0.3 Te 1/4/1 - External
172.30.1.0 2 13.0.0.3 Te 1/4/1 1 Intra-Area
DellEMC#
show ip ospf statistics
Display OSPF statistics.
Syntax
show ip ospf [process-id | vrf vrf-name] statistics global | [interface
name {neighbor router-id}]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display statistics
corresponding to the OSPF process that is tied to a specific VRF.
global Enter the keyword global to display the packet counts received on all running
OSPF interfaces and packet counts OSPF neighbors receive and transmit.
interface name (OPTIONAL) Enter the keyword interface then one of the following interface
keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Open Shortest Path First (OSPFv2 and OSPFv3) 1101