Deployment Guide

neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ip-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ip-address | peer-group-
name} ebgp-multihop command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the Time to Live (ttl) value. The range is
from 1 to 255. The default is 255.
Defaults Disabled.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To prevent loops, the neighbor ebgp-multihop command does not install the default routes of the
multihop peer. Networks not directly connected are not considered valid for best-path selection.
neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
Syntax
neighbor {ipv4-address | peer-group-name} fall-over
To disable, use the no neighbor {ipv4-address | peer-group-name} fall-over command.
Parameters
ipv4-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
384 Border Gateway Protocol