Deployment Guide

● IPV4Acl : 4
● IPV6Acl : 0
● IPV4Qos : 2
● L2Qos : 1
● L2PT : 0
● IpMacAcl : 0
● VmanQos : 0
● VmanDualQos : 0
● EcfmAcl : 0
● nlbclusteracl: 0
● FcoeAcl : 0
● iscsiOptAcl : 0
● ipv4pbr : 0
● ipv4udfmirracl: 0
● vrfv4Acl :0
● Openflow : 0
● fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1
to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4 ACL. The
range is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6 ACL. The
range is from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4 QoS. The
range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for L2 QoS. The
range is from 1 to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol
tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC
ACL. The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL.
The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for
nlbcluster ACL. The range is from 0 to 2. By default, the value is 0 and it supports 8
NLB arp entries reserved for internal functionality.
NOTE: When you reconfigure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
from 0 to 2. The default value is 0. At the default value of 0, eight NLB ARP
entries are available for use. This platform supports up to 512 CAM entries.
Select 1 to configure 256 entries. Select 2 to configure 512 entries. Even
though you can perform CAM carving to allocate the maximum number of NLB
entries, Dell EMC Networking recommends that you use a maximum of 64 NLB
ARP entries.
vman-qos Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS.
The range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for VMAN
dual QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL.
The range is from 0 to 8.
450 Content Addressable Memory (CAM)