CLI Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route
map used in this command. If you identify a peer by IP address, the Route map overwrites either the
inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure the router as a route reflector and the specified neighbors as members of the cluster.
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To remove one or more neighbors from a cluster, use the no neighbor {ip-address | peer-
group-name} route-reflector-client command. If you delete all members of a cluster, you also
delete the route-reflector configuration on the router.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol 403