Users Guide

ipv6 ospf hello-interval
Specify the time interval between the hello packets sent on the interface.
Syntax
ipv6 ospf hello—interval seconds
To return to the default time interval, enter no ipv6 ospf hello—interval.
Parameters
seconds
Enter the time interval in seconds as the time between hello packets. The range is
from 1 to 65525 seconds.
Defaults 10 seconds (Ethernet).
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage
Information
The time interval between hello packets must be the same for routers in a network.
Related
Commands
● ipv6 ospf dead-interval – specify the time interval between hello packets was received from a router.
ipv6 ospf mtu-ignore
Disable OSPF MTU mismatch detection on receipt of database description (DBD) packets.
Syntax
ipv6 ospf mtu-ignore
To return to the default, use the no ipv6 ospf mtu-ignore command.
Defaults Disabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
1196 Open Shortest Path First (OSPFv2 and OSPFv3)