Users Guide

Symbol Description
M Could not fragment.
? Unknown packet type.
& Packet lifetime exceeded.
Example (IPv4)
DellEMC# ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
::
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
DellEMC#
Example (IPv6)
DellEMC# ping 100::1
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:
!!!!!
Success rate is 100.0 percent (5/5), round-trip min/avg/max = 0/0/0 (ms)
DellEMC#
reload
Reboot the system.
Syntax
reload [conditional nvram-cfg-change | no-confirm [discard-running] | dell-
diag | onie [install | uninstall | rescue]]
Parameters
conditional
nvram-cfg-
change
(OPTIONAL) Reload into the Dell EMC Networking Operating System (OS) if the
condition is true. A configuration change to the NVRAM requires a switch reload.
To reload the switch, select nvram-cfg-change.
no-confirm
[discard-running]
Reload the chassis without prompting for further confirmation.
dell-diag (OPTIONAL) Reload the system into the Dell diagnostics mode.
onie (OPTIONAL) Reload the system into the ONIE mode. You can also use one of the
following options to reload the system and enter the respective modes directly:
● install — enter the Install mode and install the networking OS
● uninstall — enter the Uninstall mode and uninstall the networking OS
● rescue — enter the Rescue mode and access the file system
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
124 Control and Monitoring