White Papers

• deny icmp (for Extended IPv6 ACLs)
• deny (for IPv6 ACLs)
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options. Some commands in this
chapter may use similar names, but require different options to support the different ACL types (for example, the deny and
permit commands).
remark
Enter a description for an ACL entry.
Syntax
remark remark-number description
To remove a remark, use the no remark command.
Parameters
remark-number (Optional) Enter the remark number. The range is from 0 to 65535 for MAC ACL
and 0 to 4294967290 for IP ACL.
NOTE: You can use the same sequence number for the remark and an ACL
rule.
description Enter a description of up to 80 characters.
Defaults Not configured.
Command Modes
● CONFIGURATION-STANDARD-ACCESS-LIST
● CONFIGURATION-EXTENDED-ACCESS-LIST
● CONFIGURATION-MAC ACCESS LIST-STANDARD
● CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced the remark number as an optional value on S4810 and S4820T.
9.14.0.0 Made the remark number as an optional value.
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
180 Access Control Lists (ACL)