White Papers

Version Description
9.14(0.0) Introduced on the S5048F–ON.
9.13(0.0) Introduced on the S6100–ON and Z9100–ON.
Usage
Information
After enabling the acloptimized feature, reboot the system.
Example
DellEMC(conf)#feature acloptimized
Configuration change will be in effect after save and reload. ACL
config containing TTL, layer3 and VRF conflicts with ACL Cam optimzation
feature and these keywords would be discarded while applying the ACL.
feature aclrange
Enable the ACL range option.
Syntax
feature aclrange
Use the no feature aclrange command to disable the option.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11(0.0) Introduced on the S6000-ON, S6100-ON, Z9100-ON.
Usage
Information
After enabling the range option, create the range profiles using the aclrange profile-name
command. Reboot the system for the range profiles to come up.
Related
Commands
aclrange profile-name on page 184 — Create range profiles.
ip access-group
Assign an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-
id] [layer3] [vrf vrf-name]ip access-group access-list-name {in | out}
[implicit-permit [vlan vlan-id | vrf vrf-name | optimized] | vlan vlan-id
| vrf vrf-name | optimized] [layer3]
To delete an IP access-group configuration, use the no ip access-group access-list-
name {in | out} [implicit-permit] [vlan vlan-id][layer3]no ip access-group
access-list-name {in | out} command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
186 Access Control Lists (ACL)